Form Boards, Stakes & Screws

Form Boards
8 × 2x4
80 linear ft of form
Stakes
32 stakes
64 screws
Forms Budget
$176
At $2.20 per linear ft

How Form Material Is Counted

The forms run around the perimeter, 2 × (length + width). Each side gets enough whole boards to span it; board joints need a stake on each side, and stakes go every 3 to 4 ft in between. Use a board at least as deep as the slab: a 2x4 is really 3.5 inches deep, which suits a 4-inch slab with the base bedded slightly below it, while a 2x6 (5.5 in) suits 5 and 6-inch slabs.

  • Stakes: wood or steel, driven outside the form and screwed to it, with their tops cut flush so the screed can slide over.
  • Curves: use bendable hardboard or kerf-cut plywood, with stakes every 1 to 2 ft.
  • Release: coat the inside face with form oil so the boards strip cleanly and can be reused.

Forms are one line of the full budget; the slab cost calculator prices them with everything else.

Need a Full Project Cost Estimate?

This tool works out one part of the job. Our Concrete Slab Cost Calculator prices the whole slab: concrete, gravel base, forms, vapor barrier, reinforcement, finish, labor and delivery.

Open the Slab Cost Calculator →

Frequently Asked Questions

Use boards at least as deep as the slab: 2x4 (3.5 in actual) for a 4-inch slab, and 2x6 (5.5 in actual) for a 5 or 6-inch slab.
Every 3 to 4 feet along straight forms, plus one on each side of every board joint, and closer on curves.
About $1.50 to $3.00 per linear foot of edge for lumber, stakes and setup, so a 20 x 20 ft slab (80 ft of edge) runs about $120 to $240.

Slab Estimating & Editorial Engineering Team

Construction Cost Estimators & Civil Engineering Analysts
Our team specializes in structural flatwork estimating, concrete mix designs, and civil building codes (ACI 302.1R, ASTM C94). All calculators and cost guides are rigorously validated against live contractor material price sheets, regional aggregate indexes, and real-world project bids.