Welded Wire Mesh Sheets & Rolls

Mesh Needed
15 sheets
With 6 in overlaps at the seams
Support Chairs
36 chairs
About every 4 ft
Mesh Cost
$180 – $300

How Sheets and Rolls Are Counted

Coverage per sheet
(5 ft − 6 in) × (10 ft − 6 in)
Each seam overlaps one grid square (6 in), so a 5 × 10 sheet covers 4.5 × 9.5 ft of new area. The tool tries both directions and keeps the one that needs fewer sheets.

Sheets lie flat and are easier to keep at mid-depth, so most pros prefer them for slabs. Rolls are cheaper per square foot but want to curl back up, so they must be flattened and tied down. Either way, mesh only helps if it sits in the middle of the slab: set it on chairs (about every 3 to 4 ft) instead of pulling it up during the pour. Mesh runs about $0.40 to $0.70 per sq ft installed, against $1.00 to $1.75 for a #4 rebar grid (see the rebar calculator).

Need a Full Project Cost Estimate?

This tool works out one part of the job. Our Concrete Slab Cost Calculator prices the whole slab: concrete, gravel base, forms, vapor barrier, reinforcement, finish, labor and delivery.

Open the Slab Cost Calculator →

Frequently Asked Questions

15 sheets of 5 x 10 ft mesh with 6-inch overlaps, or one 5 x 150 ft roll.
At least one full grid square, which is 6 inches for 6x6 mesh, at every seam. Tie the overlaps with wire so they do not separate.
For patios, walks and shed pads, mesh on chairs works well to hold shrinkage cracks tight. Driveways and garage floors that carry vehicles are better served by a #4 rebar grid.

Slab Estimating & Editorial Engineering Team

Construction Cost Estimators & Civil Engineering Analysts
Our team specializes in structural flatwork estimating, concrete mix designs, and civil building codes (ACI 302.1R, ASTM C94). All calculators and cost guides are rigorously validated against live contractor material price sheets, regional aggregate indexes, and real-world project bids.