Concrete Slab Cost & Volume Estimator

Precision multi-layer project budgeting: Materials, Sub-Base, Reinforcement, Labor & Equipment

Picking a location sets the ready-mix, excavation and labor rates below to that area's typical level. You can still type your own local prices afterwards. Slab prices by state.

ft
ft
in
$
$ /sq ft
inches
$ /yd³
$ /lin ft
$ /sq ft

Closer spacing uses more steel and raises the rebar cost.

$
$ /sq ft
$

Not charged when bagged concrete is selected.

$
$
$
$ /sq ft
%
%
Live Estimate
Estimated Total Project Budget
$1,656.20
$11.50 / sq. ft.
$123.80 / m²
Based on U.S. national average rates
Order Volume (w/ Waste)
1.96 yd³
Net: 1.78 yd³
Or Bagged Equivalent
88 bags
80-lb pre-mix bags
Total Surface Area
144 sq ft (13.4 m²)
Order volume: 1.50 m³
Estimated Wet Weight
7,656 lbs
Perimeter: 48 ft
Concrete
Labor
Prep/Base
Rebar
Forms

A scaled plan of your slab: rebar grid at the spacing you chose, support chairs about every 3 to 4 ft, and the recommended control-joint saw cuts (2.5 times the thickness in inches, in feet, capped at 15 ft). It redraws as you change the inputs.

Patio Sizes and Costs (4 in thick)

Project Size Concrete (+10% waste) DIY Materials Installed
Bistro / grill pad 10 × 12 ft (120 sq ft) 1.63 yd³ (74 × 80-lb bags) $460–$650 $970–$1,680
Small dining patio 12 × 12 ft (144 sq ft) 1.96 yd³ (88 × 80-lb bags) $520–$750 $1,130–$1,970
Mid-size patio 12 × 16 ft (192 sq ft) 2.61 yd³ (118 × 80-lb bags) $630–$940 $1,450–$2,560
Dining + lounge 16 × 20 ft (320 sq ft) 4.35 yd³ $930–$1,440 $2,290–$4,100
Large entertaining patio 20 × 20 ft (400 sq ft) 5.43 yd³ $1,110–$1,750 $2,810–$5,060
Installed low end: plain broom-finish slab with ready-mix at $150/yd³ plus a $120 delivery fee, forms and labor at $3.50/sq ft. High end: the calculator's default scope (adds a vapor barrier and #4 rebar at 18 in, labor at $5.00/sq ft) plus 25% contractor overhead and profit. DIY materials: the cheaper of ready-mix or $6.50 80-lb bags, plus forms, up to vapor barrier and rebar. Site excavation and a gravel base are extra (about $1.40 to $3.30 per sq ft).

Recommended Specifications

Thickness4 in (5 in under a hot tub or outdoor kitchen)
Concrete strength3,000 PSI in mild climates; 3,500 PSI air-entrained (5–7% air) where it freezes
Base4 to 6 in of compacted crushed stone
ReinforcementWelded wire mesh or #4 rebar at 18 in; fiber mix is common on patios
Slope1/8 to 1/4 in per ft away from the house
Control jointsEvery 10 ft or closer, cut 25% of the depth

Broom, Exposed Aggregate or Stamped?

The finish is the biggest price lever on a patio. A broom finish adds about $0.50 to $0.80 per sq ft and gives a non-slip surface that is easy to repair. A smooth steel-trowel finish ($1.00 to $1.50 per sq ft) looks clean but gets slippery when wet, so it suits covered patios. Exposed aggregate ($2.50 to $4.50 per sq ft) hides dirt and wear well. Stamped concrete ($6.00 to $12.00 per sq ft for the finish alone, plus higher labor) imitates stone or brick and is the priciest, and it needs resealing every few years to keep its color.

Patio Details People Forget

  • Height at the door: keep the top of the slab at least a step below the door sill so rain and snow melt cannot run inside.
  • Isolation joint at the house: a strip of expansion joint material where the patio meets the foundation lets the two move separately.
  • Future posts and footings: if a pergola or roof may come later, pour footings now or thicken the slab where posts will land. Use the footing calculator.
  • Utilities: run a sleeve under the slab for gas, power or irrigation before you pour.

Frequently Asked Questions

About $1,450 to $2,560 installed with a broom finish at 4 inches thick, or $630 to $940 in materials if you pour it yourself. It needs 2.61 cubic yards of concrete with waste.

Four inches is standard for a patio. Go to 5 inches under a hot tub, outdoor kitchen or anywhere a vehicle might drive.

Stamped concrete costs about $13 to $22 per sq ft against $7 to $13 for broom finish. It looks like stone for much less than real pavers, but it needs resealing every few years and repairs are hard to match.

Away from the house, at 1/8 to 1/4 inch per foot (1/4 inch per foot is preferred next to a wall).

Related Guides

Slab Estimating & Editorial Engineering Team

Construction Cost Estimators & Civil Engineering Analysts
Our team specializes in structural flatwork estimating, concrete mix designs, and civil building codes (ACI 302.1R, ASTM C94). All calculators and cost guides are rigorously validated against live contractor material price sheets, regional aggregate indexes, and real-world project bids.