Concrete Foundation Slab Cost
What a monolithic slab foundation costs for a house, garage or ADU, what it includes, and where a slab is (and is not) the right foundation.
A monolithic slab-on-grade foundation costs about $7 to $14 per sq ft, so a 30 × 40 ft (1,200 sq ft) house runs roughly $8,400 to $16,800 for the slab and its thickened edges. Plumbing rough-in, engineering and permits are extra.
Concrete Slab Cost & Volume Estimator
Precision multi-layer project budgeting: Materials, Sub-Base, Reinforcement, Labor & Equipment
Picking a location sets the ready-mix, excavation and labor rates below to that area's typical level. You can still type your own local prices afterwards. Slab prices by state.
Closer spacing uses more steel and raises the rebar cost.
Not charged when bagged concrete is selected.
A scaled plan of your slab: rebar grid at the spacing you chose, support chairs about every 3 to 4 ft, and the recommended control-joint saw cuts (2.5 times the thickness in inches, in feet, capped at 15 ft). It redraws as you change the inputs.
| Scope Item / Material Description | Amount |
|---|
Enter the total your contractor quoted. We compare it with a benchmark for the same slab and scope you set in the calculator: materials at your entered prices plus labor at the regional standard rate, before any overhead or profit. Make sure the calculator scope (base, rebar, finish, pump, demolition) matches what the bid includes.
Optional: enter the bid's line items to see where the markup sits
Enter the forecast for pour day. The check follows ACI 306R (cold weather) and ACI 305R (hot weather) and estimates the surface evaporation rate that drives plastic shrinkage cracking.
Foundation Slab Sizes and Costs (4 in floor, thickened edge)
| Project | Size | Concrete (+10% waste) | Installed |
|---|---|---|---|
| Small house / ADU | 24 × 32 ft (768 sq ft) | 15.56 yd³ | $5,400–$10,800 |
| Ranch, 1,200 sq ft | 30 × 40 ft (1,200 sq ft) | 22.76 yd³ | $8,400–$16,800 |
| Ranch, 1,600 sq ft | 32 × 50 ft (1,600 sq ft) | 29.33 yd³ | $11,200–$22,400 |
| Ranch, 2,000 sq ft | 40 × 50 ft (2,000 sq ft) | 35.53 yd³ | $14,000–$28,000 |
Recommended Specifications
| Floor thickness | 4 in typical (the IRC minimum is 3.5 in); thicker under bearing walls and point loads per the plans |
|---|---|
| Thickened edge | 12 in or wider, 12 to 18 in deep or to frost depth, with 2 or more #4 bars |
| Concrete strength | 2,500 PSI minimum for foundations not exposed to weather; most builders order 3,000 or more |
| Under the slab | 4 to 6 in of compacted stone, 6-mil or heavier vapor retarder, and insulation where the energy code requires it |
| Frost | Footings below the local frost line (often 36 to 48 in in cold states) or a frost-protected shallow foundation design |
| Design | Follow stamped plans or your building department's details; soil conditions set the final design |
What the Price Includes (and What It Does Not)
The per-square-foot figure covers the slab and its thickened edges: forming, base, vapor retarder, rebar, concrete, placing and finishing. It does not cover the soil test or engineering, permits and inspections, plumbing and electrical rough-in under the slab, termite treatment, under-slab insulation, or major grading. On a house, those can add as much again as the slab itself, so get them priced separately.
When a Slab Is the Right Foundation
Slabs suit flat lots, warm and mixed climates, and single-story homes where you want no steps at the doors. They are the cheapest common foundation. A crawl space or basement makes more sense on sloped lots, where frost is very deep, or when you want easy access to pipes and ducts. Our slab vs. crawl space comparison goes through the trade-offs. Structural foundations need a design that meets your local code, so treat these numbers as a budget, not a plan.
Frequently Asked Questions
About $7 to $14 per sq ft for a monolithic slab with thickened edges, before plumbing rough-in, engineering and permits.
Roughly $8,400 to $16,800 for a 30 x 40 ft monolithic slab. It takes about 22.8 cubic yards of concrete including the thickened edges and waste.
Typically 12 to 18 inches deep and at least 12 inches wide, but it must reach below the frost line where codes require it. Your plans or building department set the exact size.
Usually, yes. A slab needs less excavation, no stem walls and no floor framing. A crawl space costs more but gives access to plumbing and works better on sloped lots.